FEATURES:
Plt1 is a single-component ink.
It has a matt appearance and an excellent covering power with a quick drying capacity.
Non-toxic ink (NT) in compliance with the EN 71/part 3 European standard.

PRINTING SUPPORT:
It can be utilised for the printing on all kinds of thermoplastic materials.
Do not utilise it for PP and PE. It is particularly indicated for stiff and soft PVC, polystyrene, and painted surfaces.

RESISTANCE:
Good resistance to alcohol and to perspiration on hand.

FLASH POINT:
Higher than 43°C

PREPARATION:
Mix and strongly dilute the ink by using the PLA thinner in the measure of max. 10-20%.
When printing fine details or screened images (e.g. 80/ 120 lines per cm) in warm environments, we recommend you add the PLD retardant in a minimum percentage.

CAUTION!
Excessive dilution generates a loss of the covering power, smudges and an imperfect detachment of the ink from the pad. An insufficient dilution causes problems of drawing the ink from the cliché, printing repeatability and dripping of the ink with a consequent decline of the printing quality.

DRYING AND HARDENING
The drying time lasts between 1 and 2 minutes at an ambient temperature of about 20°C.
If you would like it to dry in only a few seconds, you can use hot air circulation ovens (60-80 °C) or high temperature spot devices (air or infrared rays) that can be installed on the piece feeding systems (e.g. rotary tables, conveyors, etc.).
The ink is completely hardened after 24 hours.

COLOUR RANGE:
Consult the COMEC colour chart of matt hues that includes a selection of 15 standard colours plus 3 threecolour shades.
All of the colour shades can be mixed with each other.
Upon request:

• special sample colours.
• metallic gold and silver shades ready for use.